Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 Uživatelský manuál stáhnout pdf (Strana 219)

WAVECOM Monitoring System W-SPECTRA, W-SPEED Manual V1.1.0 Classifier – the Brain of W-SPECTRA



209

Classifier Code Check Sequences

From this list, the desired mode of operation of the CCC is selected. Each process performs one or more

steps to narrow down the possible candidates for eventual successful signal determination or decoding.

The availability of more or less complex processes allows the user to select the process which is best suit-

ed to his purposes.

The process selected is shown in the status line.

Process

Steps

Only classification is performed, but no decoding.

Classification and table check are performed, but no decoding.

Classification, table check and code check are performed, but no decoding.

Classification and table check are performed and finally the signal is decoded if a mode with an associat-

ed, valid detector was found.

Classification, table check and code check are performed and finally the signal is decoded if a mode with

an associated, valid detector was found.

Classifier Modulation Settings

These settings control the behavior of the classifier. See the section on “Classifier Code Check

HF/VHF/UHF (CCC)” on page 206 for details. Note that the Refresh List option is not available when the

classifier is used with the CCC.

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 291 292

Žádné komentáře

Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 Uživatelský manuál Strana 219