Wavecom TT040-50 Uživatelský manuál stáhnout pdf (Strana 16)

Wavecom Instruments Thermal Transfer Bar Code Printer User Manual

Gap/Black Mark Calibration, Self-test and Dump Mode

While calibrate the gap/black mark sensor, printer will measure the label length, print the

internal configuration (self-test) on label and then enter the dump mode. To calibrate gap

or black mark sensor depends on the sensor setting in the last print job.

Please follow the steps below to calibrate the sensor.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED becomes amber and blinking. (Any amber will do during

the 5 blinks)

 The LED color will be changed as following order.

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5 blinks) 

red/amber (5 blinks)  solid green

4. It calibrates the sensor and measures the label length and prints internal settings then

enter the dump mode.

Note: 1. Sensor calibration can be done by power on utility.

2. Please select gap or black mark sensor type prior to calibrate the sensor.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Žádné komentáře

Wavecom TT040-50 Uživatelský manuál Strana 16